Pocket Wizard CM-N3-ACC-1

PocketWizard Compatibility:          

•  PlusX (trigger only)
•  Plus III
•  FlexTT5
•  MultiMAX with -ACC port

Description: This is a special remote shutter release cable called a Pre-Trigger cable.  A pre-trigger cable controls both the half-press and full-press function of your remote camera’s shutter release.  When a camera is “pre-triggered”, it is like holding your camera’s shutter release button in the half-pressed or metering/focusing position.

This –ACC cable allows a compatible PocketWizard radio to independently control both half-press and full-press functions.

A Standard Cable works with most PocketWizard radios but has no half-press control, and is for basic remote triggering only. (Using a CM-N3-ACC cable with a MSMM Adapter will provide the same function as a CM-N3 cable.)

A -P Cable works with most PocketWizard radios.  This pre-trigger cable has a switch that allows you to toggle half-press on or off at the remote camera's position, but not from the transmitting radio. (Using a CM-N3-ACC cable with a PTMM Adapter will provide the same function as a CM-N3-P cable.)

Compatible with the following radios:

PlusX: Use this cable with the PlusX to trigger the camera. 

Plus III: Use this cable with the Plus III’s exclusive 2-stage trigger to wake-up or focus your remote camera just like using the camera’s shutter release button.  

Plus II or MultiMAX with no -ACC port: Use the MSMM adapter with this CM-N3-ACC cable or use the CM-N3.

MultiMAX with –ACC port: Enable a remote zone with your hand-held MultiMAX, and your remote MultiMAX will wake up its remote camera with this cable.  As long as the zone is turned on, the remote camera will stay awake and respond more quickly and consistently, but also consume the camera's batteries much more quickly.  When the remote zone is disabled, the camera will enter its normal sleep modes.  The MultiMAX does not support the 2-stage trigger function. 

FlexTT5: This cable is required for auto-relay mode with TTL, or other remote triggering with the FlexTT5.   You can use a CM-N3-P cable or CM-N3 standard cable with a FlexTT5, but your remote camera will not be able to relay a TTL signal to speedlights.  The FlexTT5 does not support the 2-stage trigger function.

Compatible with cameras using Canon's N3 remote terminal including:

Canon	Canon	Canon	Kodak
EOS 1	EOS-1V	EOS 20D	DCS 560
EOS-1D Mark II	EOS-1V HS	EOS 30D	DCS 520
EOS-1D Mark IIN	EOS-3	EOS 40D
EOS-1D Mark III	EOS 5D	EOS 50D
EOS-1D Mark IV	EOS 5D Mark II	EOS D30
EOS-1Ds	EOS 5D Mark III	EOS D60
EOS-1Ds Mark II	EOS 6D	EOS D2000
EOS-1Ds Mark III	EOS 7D
EOS-1D X